MIL-PRF-85322C
3.10.2 Lid (Component A only). Each lid of Component A material shall bear a red printed
label with the following information:
·
USE CAUTION
·
OPEN SLOWLY
3.10.3 Precautions. Each kit shall include a sheet listing the following precautions:
a. Open Component A (pigmented) carefully. Some outgassing may be evident. Do
not open any container that is bulged or deformed. Discard any container that is
bulged or deformed.
b. All spray equipment shall be adequately grounded. Clean equipment thoroughly
after each use with thinner conforming to MIL-T-81772, Type I.
c. Mix only the number of kits that can be used within two hours. Keep containers
closed when not in use.
d. Wear protective clothing, creams, gloves and goggles while spraying.
e. An air-line respirator is recommended for spraying operations. If it is not available,
protective masks containing an organic-vapor cartridge respirator should be used.
f. Do not contaminate Components A or B with alcohol or water.
g. Keep containers closed when not in use. Both components are moisture sensitive.
h. Wash hands immediately after use.
i. Dispose of, without opening, any container that is bulged or deformed.
j. Perform production type operations only in specifically designated areas with local
exhaust ventilation and other environmental control measures, as may be
recommended on the basis of an on-site industrial hygiene survey.
4.
VERIFICATION
4.1 Classification of inspections. The inspection requirements specified herein are
classified as follows:
a. Qualification inspection (see 4.3).
b. Conformance inspection (see 4.4).
4.2 Inspection conditions. Unless otherwise specified, all inspections shall be performed in
accordance with the conditions specified in ASTM D3924, and testing shall be performed in
duplicate. Unless otherwise stated in the test method or paragraph herein, room temperature
shall be 21° ±5 °C (70° ±10 °F) and relative humidity as 50 ±10 percent.
4.3 Qualification inspection. The qualification inspection shall consist of all tests specified
in 4.6 and table III.
10
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business