TT-B-1325D
3.2.6 Resistance to acid. When tested as specified in 4.3.6, the beads shall not develop any surface haze or dulling.
3.2.7 Resistance to calcium chloride. When tested as specified in 4.3.7, the beads shall not develop any surface haze or dulling.
3.2.8 Resistance to sodium sulfide. When tested as specified in 4.3.8, the sodium sulfide should not darken the beads.
3.2.9 Water resistance. When tested as specified in 4.3.9, the water shall not produce haze or dulling of the beads, and not more than 4.5 mL of 0.1 N hydrochloric acid shall be used in the titration.
3.3 Material Safety Data Sheet. A Material Safety Data Sheet (MSDS) shall be submitted in accordance with FED-STD-313 (see 6.2).
4. QUALITY ASSURANCE PROVISIONS.
4.1 Responsibility for inspection. Unless otherwise specified in the contract, the contractor is responsible for the performance of all inspection requirements as specified herein. Except as otherwise specified in the contract, the contractor may use his own or any other facilities suitable for the performance of the inspection requirements specified herein, unless disapproved by the government. The government reserves the right to perform any of the inspections set forth in the specification where such inspections are deemed necessary to assure that supplies and services conform to prescribed requirements.
4.2 Quality conformance inspection.
time.
4.2.1 Lot. A lot shall consist of all beads of one type offered for inspection at one
4.2.2 Inspection of preparation for delivery. An inspection shall be made to determine that the packing and marking comply with Section 5 of this specification. The sample unit shall be one filled shipping container for each ten ordered, randomly selected from the lot.
4.2.3 Sampling of the end item. Sampling shall be random in the ratio of 45 kg (100 lb) sample (in full bags) per 4,535 kg (10000 lb) shipped. Upon delivery, the material shall be reduced in a sample splitter to a size of approximately 1 kg (2.2 lb). The sample shall be submitted to the laboratory for testing.
4.2.4 Certificate of compliance. When Type I or Type IV beads are offered for inspection, the manufacturer shall certify that the beads conform to the requirements of
3.1.
Source: https://assist.dla.mil -- Downloaded: Check the source to verify that thi4s is the current version before use.
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business