A-A-2962A
5.2 Classification of inspections. Inspections shall be classified as follows:
5.2.1 Quality conformance inspection. All requirements listed under Section 3.0, or typical results may be offered for commercial products, based on earlier test results, provided they represent the same formulation and raw material sources. In case of dispute, questionable test results or questionable product quality, the Government reserves the right to require the manufacturer to demonstrate compliance to any Section 3.0 requirement, by a third party test laboratory or witness testing in the manufacturer’s laboratory.
5.2.2 Inspection prior to delivery. Requirements are marked by an asterisk(*) in the table(s).
6.0 PACKAGING, LABELING, and MATERIAL SAFETY DATA SHEETS (MSDS).
6.1 Packaging. Shall comply with the minimum applicable requirements in accordance with ASTM D 3951. Unless otherwise specified in the contract or purchase order, the material shall be supplied in the following size containers; 3.78 liter (1.0 gallon); 0.945 liter (1.0 quart) and 18.9 liter (5.0 gallons). Gallon and quart containers shall have resealable compression type lids. The top and bottom rims shall be compound-lined. Box packing shall be in accordance with normal commercial practice and shall be adequate to protect the product packaging in normal handling and shipping.
6.2 Labeling. Shall conform to ANSI Z1291.1
Mark of containers. Each container shall be legibly marked with:
Manufacturer’s name and address
Volatile organic content (VOC) g/L & lbs./gal
Product number
Generic type of coating
Color
Lot or batch number
Date of manufacture (not if in lot or batch no.)
Quantity of coating in container(s)
Instructions for use
Hazard warnings required by federal and state laws
Shelf life between temperature range
Recoat guidance
Mixing ratios and procedures, if required
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business