MIL-DTL-53039 Coating, Aliphatic Polyurethane, Single Component, Chemical Agent ResistantThis specification covers single component, polymeric flattened, chemical agent resistant, aliphatic polyurethane coating for use as a finish coat on military tactical equipment, which includes ground, aviation and related support assets. Other than where noted, the materials are free of volatile organic hazardous air pollutants \(VOHAP-free\), free of inorganic hazardous air pollutants \(HAPs\) other than cobalt and non-hexavalent chromium. The coating is lead, cadmium, cadmium compounds and hexavalent chromium free.

Pages 1 - 2 - 3 - 4 - 5 - 6 - 7 - 8 - 9 - 10 - 11 - 12 - 13 - 14 - 15 - 16 - 17 - 18 - 19 - 20 - 21 - 22

MIL-DTL-53039E

(MSDSs) becomes extinct and you must ensure that each hazardous chemical in your workplace

has an SDS and only a SDS as specified in the OSHA Brief

D of 29 CFR 1910.1200 (see:

4. VERIFICATION

4.1 Classification of inspections. The inspection requirements specified herein are classified as

follows:

a. Qualification inspection (see 4.2).

b. Extension of qualification inspection (see 4.3).

c. Conformance inspection (see 4.4)

4.2 Qualification inspection. Qualification shall be conducted by the qualifying activity (see

6.4). The qualification test sample shall consist of four quarts of the paint. The samples shall be

legibly identified (see 6.4.3). Qualification inspection shall consist of tests for all requirements

in section 3 and table X. Qualification inspection shall examine for user instruction marking (see

3.7). The results of each test shall be compared with the applicable requirement in section 3.

Failure to conform to any requirement shall be counted as a defect, and paint represented by the

sample test shall not be approved for inclusion in the QPD under this specification.

4.3 Extension of qualification inspection. Qualification inspection (see 4.2) shall be performed on

the colors listed in the left column of table IX. These ten (10) primary colors shall require full

qualification testing. These colors shall be approved first for inclusion in the QPD under this

specification in order to qualify their respective colors listed in the right column to an extension test

program. The extension test program shall test for color, infrared reflectance, accelerated weathering

(only for Aircraft Yellow, 33538 and Aircraft Red, 31136), 60 and 85 degree gloss, STB resistance,

acid resistance, accelerated storage stability, chemical agent resistance, and viscosity. The extension

test program can include limited extension testing. Limited extension testing for only color, gloss,

and STB resistance shall be determined on a case by case basis and formalized prior to testing through

test service agreements. Colors in the right column shall be listed in the QPD if they satisfy the

requirements of the extension test program. The qualification test sample shall consist of a one quart

sample of the paint. The sample and the necessary paperwork (see 6.4.3) shall be sent to the

qualifying activity (see 6.4).

TABLE IX. Qualification and extension colors.

QPD extension test program/additional colors

Full QPD testing/color qualified

to which approval is extended

Dark Green, 34082; Olive Drab, 34088;

Green 383, 34094

Field Drab, 33105

Green 808, 34102

IRR Foliage Green 504, 34160

Earth Yellow, 33245; Dark Sandstone, 33510;

Tan 686A, 33446

Sand, 33303; Tan, 33531

Woodland Desert Sage, 34201

Brown 383, 30051