INCH-POUND
MIL-PRF-87978A
31 December 1996
SUPERSEDING
MIL-R-87978
1 August 1987
PERFORMANCE SPECIFICATION
REMOVER, PAINT, EPOXY AND POLYURETHANE SYSTEMS, TANK TYPE, AMBIENT
TEMPERATURE, FOR AIRCRAFT WHEELS AND LANDING GEAR COMPONENTS
This specification is approved for use by all Departments and Agencies of the Department
of Defense.
1. SCOPE
1.1 Scope. This specification establishes the requirements for two types of tank type paint
removers for use on aircraft wheels and landing gear components at ambient temperature.
1.2 Classification. Paint remover covered by this specification shall be of the following types, as
specified (see 6.2):
Type I
-
One Step
Type II
-
Two Step (Paint Remover A and Paint Remover B)
2. APPLICABLE DOCUMENTS
2.1 General. The documents listed in this section are cited in sections 3 and 4 of this
specification. These lists do not include documents cited in other sections of this specification or
recommended for additional information or as examples. While every effort has been made to
ensure the completeness of these lists, document users are cautioned that they must meet all
specified requirements documents cited in sections 3 and 4 of this specification, whether or not
they are listed.
Beneficial comments (recommendations, additions, deletions) and any pertinent data that may be
of use in improving this document should be addressed to: WR-ALC/LKJE, 460 2nd St., STE
221, Robins AFB, Georgia 31098-1640, by using the Standardization Document Improvement
Proposal (DD Form 1426) appearing at the end of this document or by letter.
AMSC N/A
FSC 8010
DISTRIBUTION STATEMENT A. Approved for public release; distribution is unlimited.
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business