gal\)\) as applied. The specified type II coating contains corrosion inhibiting pigments, formulated free of hazardous air pollutants \(HAP-free\).

Pages 1 - 2 - 3 - 4 - 5 - 6 - 7 - 8 - 9 - 10 - 11

MIL-DTL-11195H

ASTM D3271

- Standard Practice for Direct Injection of Solvent Reducible Paints Into a

Gas Chromatograph for Solvent Analysis. (DoD adopted)

ASTM D3335

- Standard Test Method for Low Concentrations of Lead, Cadmium, and

Cobalt in Paint by Atomic Absorption Spectroscopy. (DoD adopted)

ASTM D3359

- Standard Test Methods for Measuring Adhesion by Tape Test.

ASTM D3363

- Standard Test Method for Film Hardness by Pencil Test. (DoD adopted)

ASTM D3891

- Standard Practice for Preparation of Glass Panels for Testing Paint,

Varnish, Lacquer, and Related Products.

ASTM D3924

- Standard Specification for Standard Environment for Conditioning

and Testing Paint, Varnish, Lacquer, and Related Materials. (DoD adopted)

ASTM D3960

- Standard Practice for Determining Volatile Organic Compound (VOC)

Content of Paints and Related Coatings. (DoD adopted)

ASTM D5380

- Standard Test Method for Identification of Crystalline Pigments and

Extenders in Paint by X Ray Diffraction Analysis.

ASTM D6677

- Standard Test Method for Evaluating Adhesion by Knife.

ASTM E1347

- Standard Test Method for Color and Color Difference Measurement by

Tristimulus Colorimetry.

(Copies of these documents are available from www.astm.org or ASTM International, 100 Barr

Harbor Drive, PO Box C700, West Conshohocken, PA 19428-2959.)

2.4 Order of precedence. Unless otherwise noted herein or in the contract, in the event of a

conflict between the text of this document and the references cited herein, the text of this

document takes precedence. Nothing in this document, however, supersedes applicable laws and

regulations unless a specific exemption has been obtained.

3. REQUIREMENTS

3.1 Qualification. The coating furnished under this specification shall be products which are

authorized by the qualifying activity for listing on the applicable Qualified Products Database

(QPD) at the time set for opening of bids (see 4.2 and 6.3). Any change in the formulation or

processing of a qualified product shall necessitate its requalification. The material supplied under

the contract shall be identical, within manufacturing tolerance, to the product that received

qualification.

3.2 Materials. The materials used in the coating shall be as specified herein. Materials not

specified shall be selected by the contractor and shall be subject to all provisions of this

specification.

3.2.1 Toxic products and formulations. The material shall have no adverse effect on the health of

the personnel when used for its intended purpose. Questions pertinent to this effect shall be

referred by the contracting activity to the appropriate departmental medical service, which will

act as an advisor to the contracting agency.

3.2.2 Hazardous material. The contractor shall comply with the hazardous material requirements

of FED-STD-313 (see 6.4).