gal\)\) as applied. The primer is also formulated free of hazardous air pollutants \(HAP-free\). This primer is not to be used on tactical or combat equipment. Equipment primed with this material is not to be coated with chemical agent resistant coating \(CARC\) primers or topcoats.

Pages 1 - 2 - 3 - 4 - 5 - 6 - 7 - 8 - 9 - 10 - 11 - 12 - 13 - 14 - 15 - 16 - 17 - 18 - 19 - 20 - 21 - 22 - 23 - 24

MIL-DTL-11414F

Specify the reason for submitting the samples.

Specification MIL-DTL-11195H; Type II, Color ____, Color Number____.

"Enamel, Lusterless, Fast Dry, VOC Compliant, (For Use On Ammunition And Other

Metals)".

Provide a copy of the MSDS.

Provide a copy of the notarized statement of composition.

Provide a copy of the technical data sheet.

Provide a copy of the test report.

6.3.2 Conformity to qualified sample. All lots of coatings supplied under this specification must

be manufactured using the same formulation, raw materials and supplier(s) of raw materials,

methods of manufacture, equipment, and geographic location as the qualification sample, unless

changes have been approved by the qualifying activity.

6.3.3 Retention of qualification. To retain qualification of products approved for listing in the

QPD, the manufacturer will be requested to verify by certification to the qualifying activity that

its product(s) comply with the requirements of this specification. Unless otherwise specified by

the qualifying activity, the time of periodic verification by certification will be in two year

intervals from the date of original qualification and will be initiated by the qualifying activity.

6.3.4 Toxicity clearance request. Department of the Army Regulation (AR) 40-5, Preventive

Medicine, (AR) 70-1, Acquisition Policy, and Department of the Army Pamphlet 70-3, Acquisition

Procedures, require a toxicity clearance. Army toxicity questions and/or a toxicity clearance

request should be addressed to: Commander, US Army Center for Health Promotion and

Preventive Medicine, ATTN: MCHB-TS-TTE, 5158 Blackhawk Road, APG, MD 21010-5403.

6.4 MSDS. Contracting officers will identify those activities requiring copies of a completed

MSDS prepared in accordance with FED-STD-313. The pertinent Government mailing addresses

for submission of data are listed in FED-STD-313.

6.5 Conformance rejection and retest. Failure in any conformance inspection will result in the

rejection of the batch from which it was obtained. Rejected material cannot be resubmitted for

acceptance without written approval from the qualification activity (see 4.4). The application for

resubmission will contain all details concerning previous rejections and measures taken to

correct these deficiencies.

6.6 Subject term (key word) listing.

Ammunition

HAP-free

Lead

Pigment

Reactivity

Surfaces