MIL-DTL-12276E(MR)
4.4.1 Test failures. A lot shall be rejected for failure to meet any of the test requirements
when tested in accordance with 4.3
5. PACKAGING
5.1 Packaging. For acquisition purposes, the packaging requirements shall be as specified in
the contract or order (see 6.2). When packaging of materiel is to be performed by DoD or in-
house contractor personnel, these personnel need to contact the responsible packaging
activity to ascertain packaging requirements. Packaging requirements are maintained by the
Inventory Control Point's packaging activities within the Military Service or Defense
Agency, or within the military service's system commands. Packaging data retrieval is
available from the managing Military Department's or Defense Agency's automated
packaging files, CD-ROM products, or by contacting the responsible packaging activity.
6. NOTES
(This section contains information of a general or explanatory nature that may be helpful,
but is not mandatory.)
6.1 Intended use. Types I and III varnishes covered by this specification are intended for
use as finishes on steel cartridge cases to protect them from atmospheric corrosion. Classes
A and B of type I and Classes A, B, and C of type III may be used depending upon the type
of equipment used to produce the finish on the cartridge cases. Type I is intended for use
where the metal is not deformed or fabricated after coating. Type III is intended for use
where the metal is deformed or fabricated after it is coated. Type II varnish covered by this
specification is intended for use as a protective finish for lining munitions, chemical and
other containers requiring special protection.
6.2 Ordering data. Procurement documents should specify the following:
a.
Title, number, and date of this specification.
b.
Specify classification, composition, type, and class (see 1.2).
c.
If sampling, inspection or testing is different then as specified (see 4.2.2).
d.
If contractor's facility is not allowed for performing inspection (see 4.2.3).
e.
Packaging requirements (see 5.1).
6.3 Marking. Suggested wording to be included in the contract or purchase order "Marking
for shipment and storage should be in accordance with MIL-STD-129". The requirements
for packaging and for packing and marking for shipment (see 5.1) specified herein apply to
direct shipment to Government activities and apply also, where specified, to contracts or
orders between the manufacturer and the Government prime contractor.
6.4 Composition L. Composition L varnish should be specified for use in areas with
regulations controlling the emission of solvents into the atmosphere.
12
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business