MIL-PRF-14105E
4.28 Toxic ingredients. Other than PCBTF, the manufacturer shall certify that the primer
contains no benzene, chlorinated solvents or ethylene based glycol ethers and their acetates.
Check for compliance with 3.6.13. Nonconformance to 3.6.13 shall constitute failure of this test.
4.29 HAP ingredients. The manufacturer shall certify that the paint contains no HAP. Check for
compliance with 3.6.17. Nonconformance to 3.6.17 shall constitute failure of this test.
5. PACKAGING
5.1 Packaging. For acquisition purposes, the packaging requirements shall be as specified in the
contract or order (see 6.2). When packaging of materiel is to be performed by DoD or in-house
contractor personnel, these personnel need to contact the responsible packaging activity to
ascertain packaging requirements. Packaging requirements are maintained by the Inventory
Control Point's packaging activities within the Military Service or Defense Agency, or within the
military service's system command. Packaging data retrieval is available from the managing
Military Department's or Defense Agency's automated packaging files, CD-ROM products, or
by contacting the responsible packaging activity.
6. NOTES
(This section contains information of a general or explanatory nature that may be helpful, but is
not mandatory.)
6.1 Intended use. This paint is intended for use on solvent degreased and blasted steel surfaces of
components which are subject to temperatures as high as 1,400 °F (760 °C) and exterior
weathering. Components such as mufflers, exhaust manifolds, and exhaust pipes may be
protected by the use of this paint. The paint provides excellent protection against corrosion and
chemical attack.
6.2 Acquisition requirements. Acquisition documents must specify the following:
a.
Title, number, and date of the specification.
b.
Type of coating (see 1.2).
c.
Part or identifying number (PIN) (see 1.2.1).
d.
Color required (see 3.2).
e.
Composition of paint (see 3.4).
f.
Whether a MSDS is required with each shipment (see 3.6.15 and 4.5).
g.
If a toxicity clearance is required (see 3.6.16).
h.
If qualification samples are required and where to send them (see 4.2 and 6.4).
i.
If extension of qualification samples are required and where to send them
(see 4.2.1 and 6.4).
j. If conformance samples are required and where to send them (see 4.3).
k. Lot and batch formation (see 4.3.1).
l. Packaging requirements (see 5.1).
6.3 Basis of purchase. The paint covered by this specification should be purchased by volume,
the unit being one U.S. liquid gallon of 231 cubic inches at 68 ºF (20 °C).
14
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business