MIL-PRF-23377K
Date of manufacture (month/year)
Batch number/net contents
VOC content in grams/liter
Mixing and thinning instructions
3.10.1 Component containers. Component A, component B, and component C (if
applicable) containers shall have the following warning:
"WARNING! FLAMMABLE."
3.11 Precaution sheet. A printed precaution sheet with the following information shall be
included with each kit:
PRECAUTIONS
a. The surface to be coated must be clean (free of oil, dust, etc.).
b. Spray equipment must be adequately grounded. Clean equipment immediately after use
with thinner conforming to MIL-T-81772, type II.
c. Mix only the amount of primer coating to be used within 4 hours.
d. Always add component B to component A NEVER THE REVERSE.
e. Never mix coating or individual component from one vendor with that of another
vendor.
f. Apply over pretreated metal. On fiberglass-reinforced plastic, a prior coating of wash
primer in accordance with MIL-C-8514 will facilitate stripping without damage to the
fiberglass.
g. Allow admixed coating to stand undisturbed for 30 minutes prior to use.
3.12 Strippability. The primer shall be tested in accordance with Methods A and B of
4.5.13, and a minimum of 90 percent of the coating shall be stripped by one of the methods.
4. VERIFICATION
4.1 Classification of inspections. The inspection requirements specified herein are
classified as follows:
a. Qualification inspection (see 4.2).
b. Conformance inspection (see 4.3).
4.2 Qualification inspection. Qualification inspection shall consist of all the inspections
listed in this specification. The samples shall be legibly identified (see 6.3.1.1).
4.3 Conformance inspection. The conformance inspection shall be performed on each
production batch and provided when requested by the contracting officer or the qualifying
activity (see 6.2). Conformance inspection consists of all the tests specified in 4.5, with the
exception of storage stability (see table II), accelerated storage stability (see 4.5.2), corrosion
resistance (see 4.5.8), toxicity (see 4.5.12), and strippability (see 4.5.13). There shall be no
failures (see 6.5).
9
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business