MIL-DTL-53030D
3.10 MSDS. A MSDS shall be prepared for the primer in accordance with FED-STD-313 and
forwarded to the qualifying activity (see 6.4.2). The MSDS shall be included with each shipment
of the material covered by this specification and submitted to pertinent Government agencies as
stated in FED-STD-313.
4. VERIFICATION
4.1 Classification of inspections. The inspection requirements specified herein are classified as
follows:
a. Qualification inspection (see 4.2).
b. Conformance inspection (see 4.3)
4.2 Qualification inspection. Qualification shall be conducted by the qualifying activity (see
6.4). The qualification test sample shall consist of five (5) quarts for type II. The samples shall
be legibly identified (see 6.4.3). Qualification inspection shall consist of tests for all
requirements specified in section 3 in accordance with table V, and examination for user
instruction marking (see 3.8). The results of each test shall be compared with the applicable
requirement in section 3. Failure to conform to any requirement shall be counted as a defect, and
paint represented by the sample test shall not be approved for inclusion in the QPD under this
specification. Conditional approval shall be given until completion of the weathering test. Upon
completion of this test, then final approval shall be given.
4.3 Conformance inspection. The manufacturer shall forward from each production lot
(see 4.3.1) a batch validation letter detailing the batch number, manufacturer's code, specification
and type number, QPL number and batch volume to U.S. Army Research Laboratory (ARL),
ATTN: RDRL-WMM-C, Organic Coatings Team, Building 4600, Deer Creek Loop, Aberdeen
Proving Ground (APG), MD 21005-5066. The manufacturer shall perform conformance
inspection testing on each production lot and have these test results on file when requested by the
contracting officer. Conformance inspection for individual lots shall test for VOC, condition in
container, total solids, fineness of grind, mixing properties, spraying properties, drying time, and
60 degree specular gloss. There shall be no failures (see 6.6).
4.3.1 Lot and batch formation. Unless otherwise specified in the contract or purchase
description (see 6.2), a lot shall consist of all coatings of the same type, composition and color,
from a single uniform batch, produced and offered for delivery at one time (see 6.4.4). Unless
otherwise specified in the contract or purchase description (see 6.2), a batch shall consist of all
coating material (in U.S. gallons) manufactured during one continuous operation and forming
part of one contract or order for delivery (see 6.4.4). The addition of any substance to a batch
shall constitute a new lot.
4.4 Inspection conditions. Unless otherwise specified, all inspections shall be performed in
accordance with ASTM D3924. Also, unless otherwise stated in the test method or paragraph,
room temperature shall be 73 ± 4 ºF (23 ± 2 ºC) and a 40 - 70 percent range relative humidity.
4.4.1 MSDS. The MSDS shall address all components of the primer and be in compliance with
the requirements of FED-STD-313. Nonconformance to 3.10 shall constitute failure of this
requirement.
10
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business