TT-P-28H
4.5.17 Hazardous solvent content. Content of hazardous solvents shall be determined in accordance with methods
7356 and 7360 of FED-STD-141. Solvent fractions shall be identified in accordance with ASTM E1252. Test results shall be reported as percent by weight of the total paint. The test results for each solvent shall be in accordance with the requirement in 3.3.2 and Table II.
4.5.18 Hazardous pigments and additives. Soluble and total metal content, except tantalum and tungsten, shall be determined on a dry paint film of the coatings in accordance with EPA SW-846, (TCLP) Toxicity Characteristic Leaching Procedure, and the appropriate test listed below. Asbestos shall be analyzed in accordance with OSHA Validated Analytical Method ID-191, "Polarization Light Microscopy of Asbestos" and test result reported as percent by weight of the dry paint film. Soluble metal content shall be reported as milligrams per liter (mg/L). Total metal content shall be reported as %WT of the dry paint film. The test results for metal shall be in
conformance with the appropriate requirements of 3.3.3 and Table III. Tantalum and tungsten soluble metal content and total metal content shall be analyzed as specified in 4.5.18.1.
TABLE VI. Physical and chemical test methods of materials.
Metal/material |
Test methods for evaluating solid waste - physical/chemical methods, SW-846 digestion test method |
All metals, except chromium (VI) |
3050 |
Chromium (VI) |
3060 |
Antimony |
7040 or 7041 |
Arsenic |
7060 or 7061 |
Barium |
7080 or 7081 |
Cadmium |
7131 |
Total chromium |
7190 |
Chromium (VI) |
7195, 7196, or 7197 |
Lead |
7421 |
Barium |
7080 or 7081 |
Nickel |
7520 or 7521 |
Selenium |
7740 or 7741 |
Silver |
7760 or 7761 |
Beryllium |
210.1 or 210.2 |
Cobalt |
219.1 or 219.2 |
Copper |
220.1 or 220.2 |
Fluoride |
340.1, 340.2, or 340.3 |
Molybdenum |
246.1 or 246.2 |
Thallium |
279.1 or 279.2 |
Vanadium |
286.1 or 286.2 |
Zinc |
289.1 or 289.2 |
4.5.18.1 Tantalum and tungsten content. Determine the tantalum and tungsten content of the paint using any appropriate spectroscopy test method. Conduct the tests in accordance with the instrument manufacturer's
directions for the use of the instrument. Manufacturer is responsible for establishing data supporting the test method choice and analytical accuracy. The test results for tantalum or tungsten shall be in conformance with the
requirements of 3.3.3.
14
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business