gal]\) as supplied by the manufacturer.

Pages 1 - 2 - 3 - 4 - 5 - 6 - 7 - 8 - 9 - 10 - 11

MIL-PRF-85582E

1.3 Part or Identifying Number (PIN). The PIN to be used for primer coatings acquired to

this specification is created as follows:

M85582

XXXX

Specification identifier

Type designator

Class designator

Kit size designator

1 = Type I

(C1, C2, or N)

(see 1.3.1)

2 = Type II

1.3.1 Kit size. The primer coatings covered by this specification should be purchased by

volume, the unit being a kit containing two components. The kit component sizes need not be of

the same size. When this part numbering system is used, the kit size is to be identified as

follows:

Kit size 1/

Kit size designator

Less than one pint

4-pint (0.47-liter)

004P

4-quart (0.95-liter)

004Q

4-gallon (3.79-liter)

004G

1/ The kit size and its designator may be modified for ease of procurement and is not otherwise

limited.

2/ Designators for less than pint size kits (small touch up kits) are expressed in cubic

centimeters (cc) and designated by "C." Example: A type I, class C1, 50 cc kit is designated

M85582-1-C1-050C.

2. APPLICABLE DOCUMENTS

2.1 General. The documents listed in this section are specified in sections 3 and 4 of this

specification. This section does not include documents cited in other sections of this

specification or recommended for additional information or as examples. While every effort has

been made to ensure the completeness of this list, document users are cautioned that they must

meet all specified requirements of documents cited in sections 3 and 4 of this specification,

whether or not they are listed.

2.2 Government documents.

2.2.1 Specifications and standards. The following specifications and standards form a part

of this document to the extent specified herein. Unless otherwise specified, the issues of these

documents are those cited in the solicitation or contract.

FEDERAL SPECIFICATION

TT-R-2918

Remover, Paint, No Hazardous Air Pollutants (HAPs).