gal\) maximum] volatile organic content \(VOC\) complying paint. The paint is a special-purpose white alkyd enamel \(Formula Number 30\) for interior use, either primed steel or primed aluminum \(see 6.1\). This product may be used wherever VOC air pollution regulations apply. Product is supplied in a single can and used as supplied without thinning.

Pages 1 - 2 - 3 - 4 - 5 - 6 - 7 - 8 - 9 - 10 - 11 - 12 - 13

MIL-DTL-1115E

ASTM E1252

Standard Practice for General Techniques for Obtaining Infrared Spectra

for Qualitative Analysis

ASTM E1347

Standard Test Method for Color and Color-Difference Measurement by

Tristimulus Colorimetry

ASTM F718

Standard for Shipbuilders and Marine Paints and Coatings

Product/Procedure Data Sheet

(Copies of these documents are available from ASTM International, 100 Barr Harbor Dr., P.O. Box C700, West

Conshohocken, PA 19428-2959 or online at www.astm.org.)

SOCIETY FOR PROTECTIVE COATINGS (SSPC)

SSPC-SP 10

Near-White Blast Cleaning

(Copies of this document are available from SSPC Publication Sales, 40 24th Street, 6th Floor, Pittsburgh, PA

15222-4656 or online at www.sspc.org.)

2.4 Order of precedence. Unless otherwise noted herein or in the contract, in the event of a conflict between

the text of this document and the references cited herein, the text of this document takes precedence. Nothing in this

document, however, supersedes applicable laws and regulations unless a specific exemption has been obtained.

3. REQUIREMENTS

3.1 First article. When specified (see 6.2), a sample shall be subjected to first article inspection in accordance

with 4.2.

3.2 Formula. The enamel shall consist of an alkyd resin, pigments, extender pigments, and solvent which,

when combined, shall result in a paint conforming to the requirements of the applicable paragraphs of this

specification.

3.2.1 Formula no. 30. The formula in table I is designated Navy Standard Formula No. 30. When Formula No.

30 is specified, or when this specification is referenced without reference to formula number, the enamel shall

conform to the requirements of this section. Manufacturers may use alternate ingredients as long as the alternate

ingredients are specifically approved by the Naval Sea Systems Command and the enamel is shown to meet all the

requirements by first article testing and conformance testing (see 4.2 and 4.3). Conformance testing may be

conducted by the Government at any time to verify that the product being acquired meets the requirements of the

specification.

3.2.2 Composition. The paint shall consist of the ingredients listed in table I and its footnotes in the

proportions shown in table I and table II. In addition, to assist in meeting drying times, brushing, condition in

container, and storage stability requirements, driers, antisettling, antisagging, and antiskinning agents may be varied

as necessary to meet the other requirements of this specification.